SUNLU FilaDryer S2 is a filament dryer designed to enhance 3D printing by effectively removing moisture from filaments.
Features:
- 360° surround heating with up & down heating plates, heat efficiently with a built-in fan.
- Heating temp. Up to 70°C, can dry PA/PC special filament and more.
- Large LED touch-screen.
- Intelligent temp control.
- Real-time humidity detection.
Specs:
- Product size: 265(L)*118(W)*274(H)mm
- Filament diameter: 1.75/2.85/3.0mm
- Working humidity: ≤90%
- Working temp: 35°C~70°C
- Input power: AC 100V-240V,50/60HZ
- Output power: DC:24V土1.2V, 2a
- Standby power: 0.05w
- Max working power: 48w
- LCD screen size: 3.43*2.87 inch
Sunlu S2 Filament Dryer Box
Customer Reviews
4.0
2 reviews
Verified purchases only.
Powered by Bazaarvoice.
Does the job
Bought this and have been using it for about two months now. There is a design flaw where it doesn’t let the condensation out, meaning you need to either drill a hole in the lid towards where it opens, or you can 3D print a part to wedge between the lid and the enclosure for a gap to allow the condensation out. It works okay once you do this. A few things to note - only reaches up to 70 degrees, ASA and ABS can be dried at a higher temperature. This just means it will just take a bit longer to dry these type of materials, you can still use it. - Buttons aren’t physical, meaning if it’s behind your printer in an enclosed tent or hard to see spot, it’s hard to press the buttons easily. Isn’t a massive issue, just something to keep in mind. - Make your own filament dryer or buy a cheaper duel filament dryer instead of spending $150 on this basic single filament dryer if you have the time
Very good
The most beautiful filament dryer every. Works really well with PLA and PETG. Very very good dryer