Progress Bar

Skip to main content

On special

The Slic3D Dryer Box (Single spool) is a practical upgrade for any 3D printing setup that’s tired of moisture ruining prints. Its single-chamber design holds a 1Kg filament spool. A set of metal axles support your spool on ball bearings to provide low rolling resistance.

 

A built-in fan delivers full 360° hot-air circulation for fast, even drying. It reaches 50°C in just 5 minutes and 70°C in 15 minutes, so you spend less time waiting and more time printing things that actually work.

 

The Slic3D Dryer Box keeps filament dry, stable, and ready to print.

 

Key features:

  • Rapid heating: 50°C in 5 minutes, 70°C in 15 minutes
  • Even hot-air circulation for consistent drying
  • Hybrid drying technology 6 preset material modes: PLA, PETG, ABS, TPU, PA, PC
  • Overheating protection with an audible alarm
  • Adjustable temperature and drying time

In the box:

  • Dryer
  • Spool holder
  • 1m USB Type-C to Type-C Cable 
  • Manual

 

Note: USB-C PD3.0 power supply with 60w minimum output required - tested with MP3392 & MP3401.

Length:260.0 mm
Width:90.0 mm
Height:250.0 mm
Weight:1.0 g
Cable length:1.0 m
Diameter:90.0 mm

Slic3D USBC Single Filament Dryer Box

Cat. No: TL7008
1.7(3)
$69.95On special
$79.95Everyday Price
Bulk Pricing
Buy More, Save More! Bulk pricing applies automatically in cart.
Qty 1-3
$69.95 / unit
Best Value
Qty 4+
$67.95 / unit
30-Day Returns
Australian Stock
Warranty Included
Checking delivery options...

Customer Reviews

Bazaarvoice Authentic Reviews

1.7

3 reviews

5
0
4
0
3
1
2
0
1
2

Verified purchases only.
Powered by Bazaarvoice.

Good dryer held back by frustrating controls

RhysNovember 2026

It dries filament fine, and performance hasn’t been an issue (though it’s the first dryer I’ve used, so I can’t compare). The problems are all in the controls. The capacitive touch buttons often don’t register presses, so I end up selecting the wrong settings or having a cycle start before I’m ready. The default drying time is 3 hours, which is short when most filaments need around 6-8. The only way to set a realistic time is DIY mode, and DIY mode then sets the temp to the PLA preset (50°C). I still haven’t worked out how to change the temperature from there. Minor note: it doesn’t come with a power brick. A 65W USB-C brick works fine, so check you have one before buying. Overall: it does the job, but the interface makes basic setup more frustrating than it should be.

Helpful?

Expensive adapter required

JeannierOctober 2026

I had to buy an expensive 60W+ USB-C PD3.0 adapter to make this unit work, as it doesn't work with a std usb-c adapter. I should have bought the more expensive dryer in the first place.

Helpful?

Don't bother

FredwardOctober 2026

Didn't get as far as drying any filament.. Boxes comes without a power supply.. Requires a 60w USB C plug, the one available at jaycar is $58. So not a cheap filament dryer after all. Thanks to the understanding staff who allowed me to return the item. I used the refund to buy a better filament dryer from another shop. (it wasn't that much more expensive either). Sort it out Jaycar, you can't expect people to have 60w USB plugs lying around.

Helpful?