
Ideally it should be fixed to an area above your rear licence plate, or any area other suitable nearby area. The wide angle lens and minimum illumination of 0.5 Lux will you give you a more than adequate view of potential hazards behind your vehicle. Supplied with a 6m wiring and video loom cable.
Specifications:
• Sensor: PC7080D
• Format: PAL 420 TV lines
• Minimum Illumination: 0.5Lux
• Video out: 1Vp.p. 75 ohm
• Power Supply: 12Vdc
• Operating temperature: -30 - +65 deg C, RH95 maximum
Note: the video extension cable includes a red wire at each end for sending a +12v signal from the camera to headunits that need this signal to switch to the reversing camera display. Do not power the camera from this extension wire - it only needs power from the wiring harness with the red and black tinned wires.
12V Reversing Camera with Bracket
Customer Reviews
2.3
3 reviews
Verified purchases only.
Powered by Bazaarvoice.
Waste of money
nothing different to the wish / temu alternatives, worked once, then never worked again, mount snapped off not long after. wouldn’t recommend, especially for the price.
Incorrectly Wired Audio Feed - Poor Design
I bought this along with the Digitech QM3793. Wired it in. No signal. Tested everything to isolate the fault, concluded it was the camera. Got a replacement, same problem. Took it to Jaycar, they worked out the 12v Trigger wire is not isolated from the RCA connector, so everytime you wire it “correctly” according the instructions, it sends 12v straight into the camera feed and fries the camera. Ran a separate trigger wire, new camera works fine. Terrible design that doesn’t work in harmony with instructions. Mitch at Jaycar was amazing, patient and nutted through the problem until the end.
Great little camera
Does the job nicely. We have these on all of our demo kits